Warnings - Yellow Diving THERMOV Manual And Maintenance Directions

How to put-on the gloves
1. Place glove rig over your head.
2. Adjust the length of the wire to reach with the longest finger for the glove.
connector keeping your arms naturally down.
3. Pass gloves through wrist seals of your dry-suit.
4. Connect glove wire connector to supply socket.
5. Place the wires in front of your body.
6. Pass your hands through wrist seals keeping the wire on the outer side of
your wrist.
7. Put on your gloves allowing a wire to form a loop.
8. Correct the wrist seals position backwards to allow easy dry-glove
connection.
9. Put on your dry gloves and seal the ring system.
You must not wash heating gloves. When wet, do not wring, hang loose and
allow to dry. Do not iron, do not use automatic dryers.

Warnings

1. Not complying to manual directions could cause personal injury and
damage of the heating system.
2. Always check heating system before dive.
3. When planning the dive always make assumption, that heating could fail.
In any circumstances do not use any other power sources that Yellow
Diving battery packs. This can result in burns and damaging the heating
system.
4. Do not carry battery pack canister holding by E/O cord. This can cause
tearing out from sealing gland or cable break. Do not bend the E/O cord
more that 90 degrees, otherwise break may appear.
5. In any reason do not transport battery pack canister when internal
connectors under the canister cover are in live position.
6. In a case when water floods the canister or cover do not switch on the
system.
7. Take care about canister cover o-ring and sealing surfaces. Make sure that
scratches or cracks are absent. This can cause flooding the canister.
Yellow Diving heating system manual
6