Battery Packs Canisters - Yellow Diving THERMOV Manual And Maintenance Directions

6. Place the cable in a desired direction inside the dry-suit.
7. Place internal cap and click it into place.
THROU – to mount dry-suit connector please follow:
1. Punch a hole 9 mm in diameter in a chosen place of dry suit.
2. From outside of dry-suit paste a rubber pad, from inside paste connectors
container, fit the openings on both parts.
3. Use a glue intended to use with rubber, i.e. TIPTOP CEMENT SC4000 with
TIPTOP E-40 hardener. All surfaces should be tarnished and degreased,
use only a thin, even layer of glue.
4. Pass connectors through a hole in dry suit, place the pad and secure
screwing the nut.
5. Connect cables inside the container.
6. Screw the container cover.
7. Leave the suit for drying according to the directions for a glue used.

Battery packs canisters

The are two canister series for Yellow Diving heating systems:
•
H – Battery canister series with battery packs capacity from 10,4Ah to
40,8Ah, with toggle switch shielded with rubber
•
PERCH H – battery canister series with battery packs capacity from
10,4Ah to 40,8Ah with solid metal press switch
Canisters are manufactured from a single Delrin rod, lightweight
but resistant material, with great insulation capabilities. This
material is perfect for diving in any environment. Watertight E/O
cord is disconnectable under water. Battery pack is double sealed
to avoid flooding, even when canister lid is not properly closed.
Canister latches are stainless steel with secure pads. Possibility of
accidental opening is elliminated. Battery packs are delivered fully charged.
Yellow Diving heating system manual
H PERCH H
4