Flair Furnishings Slick Triple Bunk Assembly Instructions Manual

Slick Triple Bunk
MODEL :
PRODUCT SIZE :
Thank you for purchasing this product. Before starting assembly we suggest you spend a short time reading
through this leaflet, then follow the simple step by step guide.
Two persons are needed to assemble this product.
* Approximately 2 Hours
* 2 People Required
* WARNING : Top Bunks and elevated Beds are dangerous and are not recommended for children
under the age of 6.
The upper bunk must be more than 2 m from any ceiling fan.
IMPORTANT INFORMATION
1. This bunk bed is suitable for a single mattress or foam bed 920mm x 1870mm.Thickness of mattress should not exceed 200mm.
2. Children should be discouraged from playing on this bunk bed.
3. The bunk bed should be checked periodically by the owner to ensure that the guardrail, ladder and other components are
maintained in the correct position and state of repair and that all connectors are tight.
4. A bunk bed is not to be placed near a ceiling fan unless the distance between the closest points on the ceiling fan and bunk
bed is at least 2 metres.
5. Use guardrails on both sides of upper bunk.
6. Prohibit horseplay on or under bed(s).
7. Prohibit more than one person on upper bunk.
8. Use ladder for entering and leaving upper bunk.
9. If the bunk bed will be placed next to the wall, the guardrail that runs the full length of the bed should be placed against the wall to
prevent entrapment between the bed and the wall.
10. Fall from elevated beds can be fatal and death have occurred where children have fallen from elevated beds. This is
relevant for all ages.The risk is greater for younger children.
The risk of injury or death from a fall from an elevated bed compared to a non elevated bed is :
10 x greater for 7-8 year olds
7 x greater for 9-10 year olds
3 x greater for 11-12 year olds
11.Top Bunks and elevated Beds are dangerous and are not recommended for children under the age of 6.
STRANGULATION HAZARD:
12. Never attach or hang items to any part of the bunk bed that are not designed for use with the bed for example, but not limited to
hook, belt, and jump ropes.
Tools Required For Assembly
Philips Screw Driver
ASSEMBLY INSTRUCTIONS
920mm x 1930mm,1220mm x 1930mm
Tools Not Use
DO NOT USE POWER TOOLS
TO ASSEMBLE THIS PRODUCT.
USE OF POWER TOOLS WILL
INVALIDATE ANY CLAIM AND
MAY DAMAGE THIS PRODUCT
MAKING IT UNSAFE.
DO NOT USE HAMMER
1
27