Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Metallisation MK61
Summary of Contents for Metallisation MK61
-
Page 2: Important Safety Precautions
All appropriate safety precautions and risk assessments fitted with flashback arrestors. MUST be carried out prior to and during use of the system. These can be viewed in full in the complete MK61 / MK73 NEVER Release gases into an un-extracted area. -
Page 3: Connecting The System
MK61 requires Acetylene hose (Red) MUST be carried out prior to and during use of the system. Regulators & These can be viewed in full in the complete MK61 / MK73 arrestors System Manual. Fit the other ends of the hoses to the appropriate connections on Fit the oxygen and Fit all hoses to their appropriate connections on the flowboard. -
Page 4: Leak Test Procedure
Open air, oxygen and fuel gas valves Fit leak test nozzle to the pistol. LEAK TEST PROCEDURE Regulate to recommended full system pressure (as per manual). The full leak test procedure must be carried out every 6 months as per routine maintenance, after any maintenance before the pistol is lit and every time gas cylinders are changed. -
Page 5: Operating The System
Check Turn on the extraction system and ensure it is operating correctly. OPERATING THE SYSTEM ARF. Open the Drive Rollers and feed wire into the gun until it protrudes from the Air Nipple. PART 1 Pull down and twist Pull down and twist to remove bowl... - Page 6 Draw the wire back until it is flush with the front of the nozzle OPERATING THE SYSTEM 90% of coating failures are a result of poor substrate preparation. These general rules should be followed prior PART 2 to spraying: • Workpieces must be prepared in accordance with the requirements.
-
Page 7: General Maintenance
Part Number: GAS-SSP - MK61 / MK73 Standard Spares oil in the air inlet and rotate the motor slowly for a few seconds to Pack for Gas Systems. - Page 8 Fax: +44 1384 237196 Email: support@metallisation.com The information in this manual was correct at the time of publication; Metallisation disclaims liability for any inaccuracies or omissions that may have occurred. Periodically, changes are made to the information herein, and Metallisation reserve the right to make improvements and/or changes to the products described in this publication...
Need help?
Do you have a question about the MK61 and is the answer not in the manual?
Questions and answers