Download Print this page

Program Remote; Remote Troubleshooting - ULTRA LEGS Tri-Toon Installation Manual

Advertisement

14. Ensure the blocks are still in place, then press the ALL
Continue this until the alarm sounds to signal that the legs have been fully retracted.
15. Cycle the pontoon all the way up and down twice more, going slowly or pausing
periodically to allow any trapped air to release from the system. Fill oil tank as necessary.
16. The Ultra Legs
®
Final Steps:
1. Lift the pontoon into the full upright position.
2. Walking underneath, find and secure any loose wiring or hoses with cable ties.
3. Step out from underneath the boat and lower it onto the blocks until the alarm sounds.
4. Fill oil tank to within 1" of top, then secure the oil tank cap in place.

Program Remote:

Ultra Leg remote receivers allow for the programming of up to three (3) remote control units.
To program a new remote control or to reset the original remote control if the remote receiver
no longer recognizes it, follow the following instructions.
1. Locate the remote receiver in the compartment next to the hydraulic pump.
2. Disconnect the harness from between the pump and receiver.
3. Reconnect the harness between the pump and receiver. The receiver will now be in "Pairing
Mode" for 10 seconds.
4. Press and hold ON button on the remote for three (3) seconds during the pairing window.
5. The remote should now function properly.

Remote Troubleshooting:

• Each remote is equipped with a 10-minute standby timer. After 10 minutes of no commands
being sent, the remote will go into standby mode. To resume operation, press the ON button
to wake the remote and resume control. Toggle switches will remain operational on the
receiver box even if the remote is in standby mode.
• The receiver can hold up to three (3) remote pairings. Pairing a new remote after all three
pairings are filled will cycle and remove the oldest stored remote to add the newest pairing.
• If the pairing process is not able to be completed per the instructions, ensure the pump is
connected to a fully charged battery and that any battery switches are in the "on" position.
6
hydraulic system is now full.
www.ultralegs.com
button on the remote control.

Advertisement

loading

This manual is also suitable for:

3006.4611