Advertisement
Recommended Tools:
• Drill with 5/16" and 1/8" standard steel bits, 5/16" and 1/8" 8"-10" long steel bits and 2" hole saw bit
• 1/2" Ratchet with extensions and sockets
• Open end wrenches: 1/2", 9/16", 7/16", 15mm, 17mm
• Impact wrench
• C-clamps or large vise-grips (4)
• Tape measures (2)
• 1/4" socket or hex driver
• Wire & Cable Cutter
• Hex Lug & Terminal Crimper
Battery Requirements:
• Use a fully charged Starting Battery with a minimum 850 cold cranking amps, such as a
Group 27 battery.
Ultra Legs
Floor Jack:
®
Ultra Legs
offers a floor jack specifically designed to make installation of Ultra Legs
®
Contact Ultra Legs
®
INSTALLATION
Set-Up:
• Place pontoon securely onto blocks on a flat, clean and dry surface with adequate clearance
above and in front of boat. Area should be free of obstructions. A minimum of two people
should be used in the installation of Ultra Legs
ground at minimum.
Power Unit and Hoses:
1. Locate the corner-seat compartment on the deck of the pontoon; this is generally the best
location for the Power Unit. Should the corner seat compartment be too small or unavailable,
other under-seat compartments may work as well, though adjustments to cable placements
may be needed.
Note: Power Unit must not be placed in the same compartment as the pontoon battery.
2. Set the Power Unit into the chosen compartment in a position not contacting the walls of the
compartment to ensure proper fit. Mark this position.
3. Find a spot near the Power Unit large enough for a 2" hole for the hydraulic hoses. Mark this
location. Remove the Power Unit from the compartment.
4. Drill a 1/8" pilot hole at the marked location through the compartment floor and pontoon
deck being careful not to hit any wiring or puncture a pontoon. Once the pilot hole has been
established as free from wiring and safe, drill a 2" hole over the original pilot hole through
the compartment floor and pontoon deck.
5. Find the location each hydraulic hose will be placed and mark these locations.
a. Rear Leg Components: Measure 52" forward from the rear-most full crossbar in each
tunnel. Mark that location on the nearest crossbar. This location is to where rear-
running hoses will be routed.
b. Front Leg Components: Measure 42" back from the front-most full crossbar in each
tunnel. Mark that location on the nearest crossbar. This location is to where forward-
running hoses will be routed.
2
for more information.
www.ultralegs.com
. Blocks should raise the pontoon 24" off the
®
easier.
®
Advertisement
