Advertisement
Nitrogen Tyre Inflator
2. Connect the compressed Air supply to the Inlet of compressed air (A) located in the
regulator.
The inlet regulator should be set at 123PSI/8.5bar/850kPa
3. Connect the Hose with single clip-on open type chuck to AutomaticCnitrogen
inflation outlet (G) located in the unit
4. Connect the Manual nitrogen inflation outlet (I) located in the unit and the Nitrogen
inlet & Inflate ball valve (L) located in the Black Clip-on deflator&inflator by a Hose
with 2 quick couplers.
5. Connect the Compressed air outlet (H) located in the unit and the Compressed Air
inlet & Deflation ball valve (K) located in the Black Clip-on deflator&inflator by
another Hose with 2 quick couplers.
6. Turn off the Deflation ball valve (K) and the Inflation ball valve (L).
7. Turn on the Compressed air outlet (H), the Automatic nitrogen inflation outlet (G)
and the Manual nitrogen inflation outlet (I).
8. Connect the power supply.
9. Press the power switch (F) to turn on the unit.The machine will produce the
nitrogen. The Nitrogen Pressure gauge (D) located in the machine will indicate the
Nitrogen Pressure in the internal Nitrogen Storage Tank.
10.Check that the Nitrogen Pressure in the internal Nitrogen Storage Tank is higher
than 72psi/5.0bar/500kPa. The equipment is now ready to use.
CAUTION
To avoid equipment damage. The compressed Air supply must be filtered by filter
(5micron) supplied separately which is to filter the oil and water in the compressed
air.
To avoid equipment damage, never exceed the maximum inlet pressure.
The filter bowls will accumulate water and oil when the machine is in operation and
require regular emptying by means of a manual drain at the base of the bowl (Turn
anti-clockwise to open and clockwise to close).
It is important that the filter elements are replaced on a regular basis to prevent water
and oil entering the machine.
4
Model: PN-8820
Advertisement
