Superfront SIDE BESTA 1/2 Mounting Instructions

Content
Finished result
The result varies depending on the size of the frame.
1.
Clean the surfaces.
Use the supplied 3M wet wipe to clean the surfaces of
the cabinet side and the Superfront side.
2.
A ach the MountPads on the frame.
Place the frame on a hard, plane surface with the
backside down. A ach one MountPad in each corner
of the cabinet side and spread the rest as shown in
the picture to the right. Place them about 1 cm from
the front and rear edge.
Note! Do not remove the cover paper from the
MountPads yet!
IKEA CABINET BOTTOM
Safety!
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Superfront / Tegnérgatan 5 / 111 40 Stockholm / Sweden / +46 8 68 44 18 14 / info@superfront.com / www.superfront.com
Screws 23mm
(the number varies depending on the size of
the side)
FRONT VIEW
PLANE SURFACE
Mounting instructions SIDE BESTÅ 1/2
3M wet wipe
3M
VHB™
Surface Cleaner Sachet
GB
For use with 3M™ VHB™ Tapes
Poche e de Ne oyage
FR
A utiliser avec les rubans 3M™ VHB™
Reinigungstuch
DE
Für den Einsatz mit 3M™ VHB™
Distribution of MountPads.
Here's how the MountPads should be distributed on the side
of the cabinet frame.
ABOUT 1 CM
FROM THE
FRONT EDGE
ABOUT 1CM
TALLER THAN
FROM THE
140 CM.
FRONT EDGE
Continued on back page
MountPads 40x25mm
(the number varies depending on the size of the side)
BACK VIEW
BETWEEN 81 CM BEWEEN 51 CM
AND 80 CM.
AND 140 CM.
LOWER THAN
50 CM.