Superfront BRUTA WALL 1/2 Mounting Instructions

Content
Finished result
The result varies depending
on the size of the frame.
Mounting
1.
Mount the frame on the wall.
Mount your Ikea frames on the wall with the Ikea
suspension rail before mounting your parts from
Superfront.
2.
Clean the surfaces.
Use the a ached 3M wet wipe to clean the surfaces
of the cabinet and the Superfront sides and top.
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
Safety!
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
3M wet wipe
3M
VHB™
Surface Cleaner Sachet
GB
For use with 3M™ VHB™ Tapes
Poche e de Ne oyage
FR
A utiliser avec les rubans 3M™ VHB™
Reinigungstuch
DE
Für den Einsatz mit 3M™ VHB™
SIDA
Superfront /+46 8 68 44 18 14 / info@superfront.com / www.superfront.com
Mounting instructions BRUTA WALL 1/2
MountPads 10x10mm & 40x25mm
(the number varies)
3.
A ach the MountPads on the frame.
Once the frames are mounted on the wall, a ach the
smaller of the supplied MountPads to each corner of the
top of the frames. Place them inside the edge of the side
of the frame and about 1 cm from the front and back of
the frame.
NOTE! Do not remove the cover paper from
the MountPads yet!
Distribution of MountPads.
Here's how the MountPads should be
distributed on the frames.
(The number varies depending on the number of frames)
Screw 23 mm
(the number varies)
TOP
FRONT