Table of Contents
Advertisement
Appendix E
Parameters for Data Logging Option
The following describes all the different data fields contained in the .CSV (Comma
Separated Value) file generated by Probewell Connect application.
1- TEST#
2- REC#
3- DATE/TIME
4- REMOTE#
5- SOCKET#
6- FORM
7- PHASE
8- TA
9- Kh
10- MODE
11- SENSOR
12- METER ID:
13- %HL
14- %LL
15- %WT
16- %PF
17- CREEP
a) N/A
b) SKIP
This test # is given to each subsequent test conducted in the
field. The unit can store up to 100 tests. Once the tests have
been uploaded into your PC and deleted from the remote, the
test # restarts at 1.
This is a permanent record number, it cannot be modified or
deleted (already stored in remote). This number is
incremented at each new logged test. It starts at 1 and
increment by 1 up to 99999 then restarts at 1.
Stamp date and time of the test
MT-1/WT3 Remote Serial Number (same as the SOCKET#)
MT-1/WT3 Socket Serial Number (already stored in socket).
Meter form
Phase tested
Testing Amperage of meter tested
Kh of the meter tested
Mode in which test was conducted. Result can be full, quick or
custom (single).
Indicates what type of sensor was used during test. Result can
be Optical Pickup or Metercam.
Tested meter's serial number as entered by the technician in
the field.
Result of HL test in registration percentage
Result of LL test in registration percentage
Weighted average in registration percentage as calculated
with the configured ratio.
Result of PF test in registration percentage
Status and result of creep test. There are 5 possible answers:
This will be returned when the %HL and %LL error difference
falls within the acceptable error margin and no creep test
needs to be run.
This will be returned when the %HL and %LL error difference
is outside the acceptable error margin, but the technician
decided not to run a creep test.
MT-1/WT3 User Guide
Page • 79
Advertisement
Table of Contents
