REPTIL'US Thermostat DT Control Timer Manual page 4

Warning: DO NOT use the machine under the environment of over damp, high temp, strong electromagnetism interference or strong
corrosion.
Notes:
1. The power supply should conform to the voltage value indicated in the instruction and keep stability
2. To avoid the interference, the sensor down-lead and power wire should be kept a distance.
Main Functions and Parameters:
◆Temperature controlling range: 0~50℃
◆Temperature measuring range: 0~50℃
◆Resolution: 0.1℃; Accuracy: ±1.0℃
◆Input: 1 NTC sensor
◆Time unit: hour (24:00 format)
◆Product consumption: ≤3W
◆Input voltage: 220Vac±15%(standard)/50HZ~60HZ
◆Ambient Requirements: Temperature: -10~60℃; Humidity: 20%~85%℃
◆Outputs: resistive load MAX 1100W; inductive load MAX 275W; incandescent bulb MAX 220W
Icons:
: Icon flashing: Cooling output
: Upper part rapid flashing: Alarm status over temperature
Menu instructions:
Menu item
HEAT/COOL(MODE)
Daytime Temperature（SET）
Nighttime Temperature（SET）
Daytime FROM
Daytime TO
Temperature difference(DL)
Alarm over temperature
First Timing control L1:
ON: FROM, OFF: TO
Second Timing control L2:
ON: FROM, OFF: TO
Real Time
Parameters setting:
Parameters would be set according to the following circular mode in the first time. All the parameters are set and saved instantly.
First of all, make sure the power is on.
1. Choose HEAT/COOL mode:
RT​ : real-time temperature;
Press SET key for 3sec to enter HEAT/COOL mode menu and ​ M ​ flashing:
HEAT: Heating output, COOL: Refrigeration;
Press UP or DOWN key to choose mode, and corresponding mode icon will light.
2. Daytime temperature setting:
Press SET key for 3 seconds to display the default temperature value while icon SET and
then press UP or DOWN key to select the ideal temperature you want.
3. Nighttime temperature setting:
Press SET key once to display the default temperature value while icon ​ S ET​ and
ideal temperature you want.
4. Temperature e difference
Press SET key until ​ D L​ icon flashing and display current value, press UP or DOWN key to select the ideal temperature difference you want.
5. Over temperature alarm setting:
Press SET key once until lower part of icon
select the idea over temperature you want.
6. Timing setting:
Notice that while start time and end time is same, this timing control become invalid
4.1. First timing control L1:
: Icon flashing: Heating output
: Icon flashing: Daytime
Set Default value
HEAT/COOL HEAT
0.0~50.0℃ 25℃
0.0~50.0℃ 20℃
00:00—22:59 08:00
01:00—23:59 18:00
0.0~10.0℃ 3.0℃
0.0~5.0℃ 5.0℃
00:00~23:59 00:00~06:00
00:00~23:59 12:00~18:00
00:00~23:59 Real-time
flashing and display the current over temperature alarm value, press UP or DOWN key to
: Icon flashing: The timer is on;
: Icon flashing: Nighttime
Remark
COOL mode delay 1 min.
Set step 0.1℃
/
/
If TO time is earlier than FROM time, display error
message "ERR".
Set step 0.1℃
Set step 0.1℃
Disabled if FROM and TO are same
Disabled if FROM and TO are same
/
flashing,
flashing, then press UP or DOWN key to select the
4