Safety Information - PROIETTA IMPRESSIVE EVO 1200 Instruction Manual

SAFETY INFORMATION

Read the following security information carefully before performing any operations. The
product described in this manual is a lighting fixture for projecting a light beam into
outdoor environments.
Any other use is not provided by the manufacturer and therefore relieves him of any
liability for damages arising from misuse.
The only maintenance operation allowed in warranty is the replacement of the lamp. Any
other repairs must be carried out solely by the manufacturer, who denies any
responsibility for unauthorized interventions.
Warning: The surface temperature of some projector components can reach high enough
values to burn when touched directly, during and after shutdown.
Always disconnect the projector from the outlet before any maintenance operation. The
risk of electric shock if you disassemble the projector or some of its parts.
For reliable operation of the device, the ambient temperature must be between -35°C
(-31°F) and 40°C (104°F).
The projector must be positioned in such a way that the objects affected by the light
beam are at least 5 meters away from the projector lens.
Never place the projector on flammable and/or combustible surfaces.
Be sure to securely attach the projector to an architectural element that ensures its
stability and reliability. All elements used for installation (screws, bolts, brackets, etc.)
must always be adjusted to the load they need to support.
Use an M12 bolt with a self-locking nut and use a security chain in the event of a
suspended installation.
Do not place objects on the power cable and in case of damage to the manufacturer for
replacement in order to avoid dangers of electrocution.
The lamp generates UV radiation, since it's an high pressure lamp, for this reason it is
important not to look through the opening at the front of the projector to avoid damaging
your eyes. Use protective goggles to replace the lamp.
Air intakes should never be covered or clogged with any material. Be sure to provide
adequate ventilation to the projector to protect it from overheating. The projector should
not be placed in a closed installation or in a compartment that is too small and without
enough ventilation.
Never touch the projector and all its components with wet hands.
1