Troubleshooting; Obtaining Service - Fisher & Paykel DCS RF24BTL1 Installation, Operation And Maintenance Instructions

Outdoor beer dispensers
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING AND OBTAINING SERVICE
Before You Call for Service
If the appliance appears to be malfunctioning, read through
this manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a qualified service technician.
WARNING
!
Electrocution Hazard
• Never attempt to repair or perform maintenance on
the appliance until the main electrical power has been
disconnected. Turning the appliance control "OFF"
does not remove electrical power from the unit's wiring.
• Replace all parts and panels before operating.
Problem
Appliance not cold enough
(See "Adjusting the temperature" on
page 9)
Appliance too cold
(See "Adjusting the Temperature" on
page 9)
Noise or Vibration
Appliance will not run.
How to Obtain Service:
For warranty service, please contact your local service
provider or DCS Customer Care at (888) 936-7872. Before
you call, please have the following information ready:
• Model Number (the serial plate is located on the upper
left side, inner wall).
• Serial Number (the serial plate is located on the upper left
side, inner wall).
• Code (the serial plate is located on the upper left side,
inner wall).
• Date of installation
• A brief description of the problem
Your satisfaction is of the utmost importance to us. If a
problem cannot be resolved to your satisfaction, please
write or email us at:
Write:
Fisher & Paykel and DCS
Appliances Inc
695 Town Centre Drive, Suite #180 Costa Mesa
CA 92626-1902
USA
Email:
customer.care@fisherpaykel.com
Possible Cause
Control set too warm
Content temperature not stabi-
lized.
Excessive usage or prolonged
door openings.
Airflow to front grille blocked.
Door gasket not sealing properly.
Control set too cold
Door gasket not sealing properly.
Appliance not level
Fan hitting tube obstruction.
Appliance turned off
Power cord not plugged in.
No power at outlet.
21
Remedy
Adjust temperature colder. Al-
low 24 hours for temperature to
stabilize.
Allow temperature to stabilize for
at least 24 hours.
Airflow must not be obstructed to
front grille. See "clearances" on
page 4.
Replace door gasket.
Adjust temperature warmer.
Allow 24 hours for temperature to
stabilize.
Replace door gasket.
Level appliance, see "Leveling
Legs" on page 4.
Contact a qualified service techni-
cian.
Turn appliance on. See "Starting
your appliance" on page 9.
Plug in power cord.
Check house circuit.
US
CA

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcs rf24btr1Dcs rf24tr1Dcs rf24tl1

Table of Contents