Table of Contents
Advertisement
M. Secure the Vitreous Shell
CAUTION: Risk of product
damage. Do not overtighten the
screws when tightening. The
vitreous shell may chip or break
if the screws are overtightened.
Insert a screw through both grommets.
Insert a screw in both of the provided
holes and tighten. Do not overtighten.
Place a cap over each screw. The
caps should be flush with the exterior
of the shell.
N. Install the Seat
Position a bolt and washer through each of the three holes in
the toilet seat hinge.
Position the gasket on the bolts from the underside of the
hinge.
Place a plastic tapered bushing, tapered-side-down, on each
of the bolts.
Place an expansion sleeve on each bolt.
Thread a brass tapered bushing, tapered-side-up, onto each
bolt. Do not tighten at this time.
Position the seat on the toilet and align the bolts with the toilet
seat mounting holes.
Insert the bolts and sleeves into the holes.
Use a flat blade screwdriver to thread the bolts until they are
snug, but do not fully tighten at this time.
Lower the seat and check seat alignment.
Align the seat on the toilet and then carefully raise the seat to
expose the bolts.
Tighten the bolts. Do not overtighten.
Position the tab on the hinge cover with the slot in the hinge
assembly and snap the hinge cover into place.
With the seat raised, gently push the seat cover forward. The
seat and seat cover should close Slowly.
1061926-T01-A
Screw
Grommet
Cap
Hinge Cover
Cover/Seat
Bolt
Washer
Plastic Tapered Bushing
Brass Tapered Bushing
Toilet
Fig.#12
12
N.
Hinge Cover Tab
Hinge
Gasket
Expansion Sleeve
Toilet Seat Mounting Hole
Fig.#13
13
-8-
M.
Hinge Slot
Advertisement
Table of Contents
