Cisco Catalyst 3560 Getting Started Manual page 7

Step 10 Enter this information in the Network Settings fields:
• In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID
only if you want to change the management interface through which you manage the
switch. The VLAN ID range is 1 to 1001.
• In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field,
click the drop-down arrow, and select an IP Subnet Mask.
• In the Default Gateway field, enter the IP address for the default gateway (router).
• Enter your password in the Switch Password field. The password can be from 1 to 25
alphanumeric characters, can start with a number, is case sensitive, allows embedded
spaces, but does not allow spaces at the beginning or end. In the Confirm Switch
Password field, enter your password again.
Step 11 (Optional) You can enter the Optional Settings information now or enter it later by using
the device manager interface:
• In the Host Name field, enter a name for the switch. The host name is limited to 31
characters. Embedded spaces are not allowed.
• Enter the date, time, and time zone information in the System Date, System Time, and
Time Zone fields. Click Enable to enable daylight saving time.
Step 12 (Optional) Click the Advanced Settings tab on the Express Setup window, and enter the
advanced settings now or enter them later by using the device manager interface.
7