Table of Contents
Advertisement
PROCEDURE AFTER REPLACING THE U-COM, ETC.
The procedure after replacing the u-COM (microprocessor), flash ROM, etc. is as follows.
PCB Name Ref. No.
Description
MAIN
U5
MX25L12835FM2I
Procedure after Replacement
A : The software has been written. The software is not written at the time of replacement.
B : The software has been written. The software may need to be rewritten by version updates. Check the
version.
See
"FIRMWARE UPDATE
PROCEDURE" for information on writing the software.
C : The software has not been written. The software needs to be written after replacement.
See
"FIRMWARE UPDATE
PROCEDURE" for information on writing the software.
D : The software has been written. Be sure to rewrite with the latest software for your service region.
See
"FIRMWARE UPDATE
PROCEDURE" for information on rewrite the software.
Procedure
Remark
after Re-
placement
C
Flash memory : SOC(MTK)
43
Advertisement
Table of Contents
