Assembly And Use; Safety Harness - Foppapedretti Bonito Instruction Manual

1.
Assemble the 4 legs, screwing the lower part of each leg with the upper part marked with the same letter (A-A
; B-B; C-C ; D-D)
2. Screw the legs to the seat supports. CAUTION: the shorter legs must be mounted in the front and the longer
legs in the back.
3.
Install the leg frame, screwing the provided screws in the slots on the legs. Make sure the slot is on the inside.
4.
Install the footrest, attaching it with the screws provided.
5.
Insert the pad on the backrest, attach the Velcro below the armrest as shown.
6.

SAFETY HARNESS

CAUTION: using a safety harness with leg separator is essential to ensure your child's safety.
CAUTION: The tray alone being attached to the seat does not guarantee that your child is contained securely.
Always use the SAFETY HARNESS!
The highchair is equipped with a 5-point safety harness.
Unclipping the buckle: Press the button (a) and pull out the components (b)
•
Clipping the buckle: Insert the components (b) into the buckle (a); you will hear a click when they are attached
•
correctly.
Adjust the harness depending on the size of the child, using the adjusters (c).
•
Adjust the position of the straps and chest belts, depending on the height of the child.
•
The straps must be adjusted in the slots close to the child's shoulders.
•
To adjust the straps or remove the safety harness, rotate the plastic blocking ring on the safety harness "straps"
•
and "lap belt" on the rear of the backrest (d), and pull the belt out of the inside of the seat, through the slots in
the seat shell and padding.
To refit the straps, insert the plastic ring fixed to the end of the strap, through the slots in the fabric and the
•
corresponding slots in the seat shell. Rotate the ring into a vertical position, on the outer side of the backrest (e).
Make sure that it is correctly mounted and locked. When pulling the straps from the inner side of the seat, the
belts should not disengage.
Always make sure that the straps are positioned in the backrest slots placed at the same height.
•
IMPORTANT: the harness must only be used with all the components attached.
IMPORTANT: Adjust the harness correctly each time the highchair is used.
7.
Install the leg separator and attach it using the screws provided.
8.
MAKE SURE THE FEET ARE POSITIONED AS SHOWN.
9.
Install the tray using the buttons on the lower side part.
10.
Adjust the tray distance using the lower buttons.
11.
Install the storage net using the zip and Velcro ties as shown.
12.
The seat can be adjusted in 3 positions by pressing the buttons (A) while moving the seat at the same time.
CHILD SEAT VERSION
13.
Remove the lower part of the legs. Remove the tray (fig. 10), the pad (fig. 5) , safety harness (fig. 6).
14.
Remove the leg separator.
15.
Remove the leg frame.
16.
Install the rubber feet with the screws provided.
17. CAUTION: screw the upper legs. Make sure they are secure.
18.
Screw the supplied slot covers as shown.
• ENGLISH •

ASSEMBLY AND USE

10