CORNING Everon 6200 User Manual

1.
2.
GENERAL INFORMATION
The E62-H2RU is a high-power remote unit supporting cellular technologies on fiber optic
cable using the CPRI protocol. The H2 is ideal for multioperator multiband deployments of
cellular services in large coverage areas. The H2 supports up to 43 dBm output per band in
single 2T2R or dual 1T1R up to 80 MHz per band. The H2 converts an optical signal to RF
and then transmits at the relevant 3GPP band and receives the analog RF signal, conditions
it, and converts it back to optical for routing to the E2 or A2.
This document describes the installation procedure for the E62-H2 unit.
This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and
QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC
License to operate this device. NOTE: Only authorized person can enter the area where the
antenna is installed. And the person is fully aware of the potential for exposure and can exercise
control over his or her exposure by leaving the area or by some other appropriate means.
Awareness of the potential for RF exposure in a workplace or similar environment can be provided
through specific training as part of a RF safety program.
Corning Optical Communications
High-Power (E62-H2)
User Manual
Everon™ 6200
User Manual | E62-H2 | Page 1