Table of Contents
Advertisement
3-1. Selecting the Mode for Service-related
3-1.1. Actions
Select diagnostic mode (service path check mode), protection history display mode, or 232C standby
clear mode.
3-1.2. Starting up
While holding down buttons "ZONE2 SOURCE" and "STATUS" simultaneously, press the power button
to turn on the power.
Select the desired mode using the "INTERNET RADIO" button, then press the "STATUS" button to con-
firm.
3-1.3. Displaying and Selecting Each Mode
The information shown on the display switches each time the "INTERNET RADIO" button is pressed.
Press the "STATUS" button to set the currently displayed mode and restart the device.
q
1.SERVICE CHECK
Service Path Check Mode：See
"DIAGNOSTIC
The Video and Audio paths can be checked.
This function is convenient for confirming problem paths in the product and checking the
paths after repairing.
w
2.PROTECTION
The protection history can be checked.
e
4.OP INFO
Operation Info for the unit can be checked.
r
5.TUNER FRQ SET
Enables reception STEP of the ANALOG TUNER to be changed.
3-1.4. Canceling the selected mode
Press the power button to turn off the power.
MODE"
112
Advertisement
Table of Contents
