Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki F-500BAF Instruction Manual

Self-contained flaker

Hide thumbs Also See for F-500BAF:

Table of Contents

II. Installation and Operating Instructions

Remove shipping carton, tape(s) and packing. If packing material is left in the

icemaker, it will not work properly.

Ensure all components, fasteners and thumbscrews are securely in place.

1) Remove the front panel to prevent damage when installing the icemaker. See Fig. 1.

2) Remove the package containing the accessories from inside the icemaker.

3) Remove the protective plastic film from the panels. If the icemaker is exposed to the sun

or to heat, remove the film after the icemaker cools.

4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the

fan blade turns freely.

5) Check that the compressor is snug on all mounting pads.

6) See the nameplate on the rear panel, and check that your voltage supplied corresponds

with the voltage specified on the nameplate.

- See Fig. 1

a) Front Panel . . . . . Remove the screws.

(left)

b) Top Panel . . . . . . Remove the screws,

WARNING

IMPORTANT

Lift up and pull toward

you.

then lift off.

Fig. 1

Table of Contents

F-500baf-c