D I R E C T I O N S F O R U S; Readout Display 1 - Kenwood CS-5170 Instruction Manual

R E A D O U T D I S P L A Y (only C S - 5 1 7 0 )
1 1 ! P O S I T I O N S O F T H E D I S P L A Y
Displays the scale factors, cursor measure-
ment data, etc. at the following positions on
the C R T .
(2) D I S P L A Y C O N T E N T S
1 Cursor Mode
The current setting cursor mode, w h i c h depends on the
combination of the operation controls, is displayed.
AV\,AV2, AT, MAT, R A T I O , P H A S E
2 Cursor Measuring Data
The result measured by the t w o cursors is displayed. In
the V A T mode, w h e n the t w o cursors approach each
other and the measurement nears its limit, a " ? " will be
displayed in front of the measured data. T h i s s h o w s that
the measured data is not available.
3 C H 1 S c a l e F a c t o r
Displays the C H 1 vertical axis sensitivity to one division.
W h e n not in C A L mode, a " > " is displayed posterior to
C H 1 .
NOTE: T h i s is not displayed w h e n the MODE s w i t c h ©
is set to C H 2 .
4 C H 2 S c a l e F a c t o r
Displays the C H 2 vertical axis sensitivity to one division.
W h e n not in C A L mode, a " > " is displayed posterior to
C H 2 .
NOTE: T h i s is not displayed w h e n the MODE s w i t c h ©
is set to C H 1 .
5 A D D
" + " is displayed w h e n the M O D E s w i t c h © is set to
A D D .
DIRECTIONS FOR USE
Fig. 6
6 C H 2 I N V E R T
The inverted polarity of C H 2 "["
trolling the • P O S I T I O N / P U L L INV ® .
7 A S w e e p S c a l e Factor
Displays a s w e e p range selected w i t h the A S W E E P
T I M E / D I V @ .
When the S W E E P V A R I A B L E is not set to C A L mode, a
" > " is displayed posterior to A .
8 B S w e e p S c a l e Factor
Displays a s w e e p range selected w i t h the B S W E E P
T I M E / D I V if the HORIZ M O D E © is set to A L T or B.
By pulling the ^ • P O S I T I O N / P U L L x 10 M A G ®,
scale factors of the A S W E E P T I M E / D I V © and B S W E E P
T I M E / D I V © are displayed. If the HORIZ MODE © is set
to X - Y position, " X - Y " is displayed instead of A and B
s w e e p ranges.
9 Delay T i m e
The cursor mode and cursor measuring data are not dis-
played if the HORIZ M O D E © is set to A L T or B. " D E -
L A Y " is displayed in place of the cursor mode, and a
delay time is displayed in place of the cursor measuring
data.
If the triggered delay (B T R I G ' D ) is selected, " ? " is dis-
played posterior to D E L A Y .
is displayed by con-
1/10
1 5