Table of Contents
Advertisement
Fault
The drying time is too
long.
Water is leaking from
the appliance.
Water overflows when
filling the water tank.
The laundry is too
damp.
Cause and troubleshooting
→ "Running the basic appliance care programme
▶
on the appliance", Page 40
Automatic self-cleaning function rinses the appliance's
heat exchanger.
Not a fault.
1.
Do not pull out the condensation tank.
2.
Do not cancel the programme.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
The water tank for the crease-removal function is
empty.
→ "Filling the water tank", Page 35.
▶
The water tank has been filled.
Note: The overflowing water is harmless.
Do not pour any more water into the water tank.
▶
The water tank filter is soiled.
→ "Cleaning the water tank filter", Page 45.
▶
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 26
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 26.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable dryness level set.
→ "Changing the dryness level", Page 25.
▶
Drying target not adjusted.
→ "Adjusting the dryness level", Page 25.
▶
Troubleshooting en
51
Advertisement
Table of Contents
