Table of Contents
Advertisement
en Appliance care
17.2 Preparing the condensa-
tion container for the ap-
pliance care programme
Note: If the condensation is drained
using the drain hose, the condensa-
tion container must be prepared be-
fore the basic or intensive appliance
care programme.
→ "Water drain hose", Page 13
Remove the stopper from the re-
1.
cess in the condensation con-
tainer.
Insert the plug from below.
2.
a The condensation container is
ready for the appliance care pro-
gramme.
Note: If the condensation is drained
using the drain hose, perform the
above-mentioned steps after the ba-
sic or intensive appliance care pro-
gramme in the reverse order.
40
17.3 Starting the appliance
care programme
Requirements
¡ The appliance is ready to run the
appliance care programme.
→ "Preparing the appliance for the
appliance care programme ",
Page 39.
¡ The condensation container is
ready for the appliance care pro-
gramme.
→ "Preparing the condensation
container for the appliance care
programme", Page 40.
Set the programme to position 1.
1.
Press and hold
2.
Set the programme to position 4.
3.
Release
Seco.
4.
a "CP1" and the programme duration
alternate on the display.
17.4 Running the basic appli-
ance care programme on
the appliance
To remove any light soiling, you can
run a basic appliance care pro-
gramme.
Note: After a certain period of use,
the appliance automatically recom-
mends that you run the basic appli-
ance care programme. Before the
start and end of the programme, the
display shows the note "CrE" for 5
Seco.
Advertisement
Table of Contents
