Advertisement
English
(4)
Please blow in within the
5s auto detect
long beep will be heard and please keep blowing. When the beep tone
stops, sampling finishes and the test result reading will be shown on the
display immediately.
If there is no alcohol detected within
take about 5 seconds sampling and show the reading.
(5) Unit set mode ：
User can press SET 【
】 & START 【 】 keys at the same time for 2
seconds and enter unit set mode 【 Unit 】 will be shown on the 4-8
segment, the selected unit will flash. Press START 【
four different units.
mg/l
%BAC
mg/100mL
（ 0.10mg/l ≈ 0.020%BAC = 20mg/mL = 0.20‰BAC ）
When exit this unit set mode, the selected unit will be preset as default
unit. If power reset, the unit setting will also be reset.
(6) Press & hold SET 【
】 key 2 seconds can go to memory recall
mode, "MEMORY" display together with record number. The last record
will display on the screen.
(7) Press SET 【
】 key to scroll backward the memories, if the last
record is 9, then the sequence is as following.
MEMORY
MEMORY
8
......
(8) Power off:
① . Auto off, the machine will turn off automatically if no key being press
for 25 seconds.
② . Press ESC 【
】 key to enter Time Clock Mode. Press & hold
ESC
START Key for 2 second to turn off the machine.
Alert Signals
i1
alcohol tester is designed to alert user as following:
English
(5) If the difference between two successive reading is >0.1‰, user
should test again.
(6) If there is very high concentration tested, user should wait for at least
3min to perform another test)
(7) When battery indicator flashes, please charge the battery immediate-
ly. Connect the provided charge cable to USB port and the white LOGO
on the upper screen will change to RED. The RED indicator will switch
off automatically if battery is fully charged.
Specification
0 / 0,08 ~ 2,00
Range
or 0/ 0,04 ~1,00
Power Input
1 x 3.7V AAA Li ion battery
Display
15 seconds
Auto Power Off Digital LCD display with bi-color Backlighting
Breath
≥5 seconds continuous breath sample
Sampling
Recycle Time
≈25 seconds
Dimension
about 12cm (L) x 6.5cm (W) x2.4cm(T) /4.7x2.5x0.96inch
Weight
about 40g ( Device only )
Alert Level
□
□
0.2‰
0.3‰
Calibrated
Agency
CE
Approval
Accessory
6 pcs Blowing tubes (3*2 different type)
Rescue hammer
(1) User can change the machine into a rescue hammer. However, the
high impact force may damage the machine and sensor itself; i.e. ONLY
use this device to break the window as a rescue hammer for emergency
use. After high impact, you need to check whether the sensor is still in
good condition.
period. If alcohol is detected, a
5s auto detect
period, it will also
】 Key will scroll
‰BAC
MEMORY
MEMORY
......
......
3
‰BAC
or 0,008
~0,200%BAC
mg/l
or 0 / 8 ~ 200
mg/100mL
√
□
□
0.5‰
0.8‰ BAC
5
English
For measurements between 0~0.08
LOW
(0~0.008%BAC
or 0~0.04mgl).
false alarm due to environment and mouth smell
For measurements between Low Level and Alert
Safety
Level, the alcohol concentration level shows on the
Level
display with white backlight.
For measurements equal to or above the alert
Alert
concentration level, the analyzer beeps together
Level
red backlight flashes for 10 times
Time Setting
(1) Press ESC 【
】 key would change the 【 DAC 】 mode into Real
ESC
Time Clock mode for time reading, at the same time, the 【 DAC 】
indicator will would disappear.
(2) In 【 RTC 】 mode, press and hold SET 【
2 seconds and the device would enter time setting mode. The selected
digits for adjusting will flash. (SET 【
down, START 【 】 is to confirm).
(3) Press SET 【
】 & ESC 【
SET 【
】 to add number and press ESC 【
(4) Press START 【
】 once to shift the selected digit and press START
【
】 for the second time and press SET 【
hour format.
(5) Press START 【
】 for two seconds to exit the time setting mode
Caution
(1) To achieve an accurate reading, user should ensure there is no
alcohol residue inside the chamber before starting a new alcoholtest.
(2) After any 4 consecutive tests, please allow the device to rest for 2
minutes.
(3) When the product is unused, please store it in a dry environment.
(4) When low battery indicator flashes, the reading is invalid, please
recharge the battery immediately.
English
(2) Open the battery door and take the metal object under the battery.
(3) Insert the metal object into the holder on the left hand side of the
machine.
Battery
cover
Specification is subject to changes without notice
The Digital Alcohol Analyzer should be used as a general guide to the
level of alcohol in your body.
Many factors (e.g. environment gas residue, smoke & various smell
in human mouth, etc...) may affect the BAC level, so the readings
are For Reference Only.
Neither the reseller nor manufacturer accept any liability arising
from the use of the unit
Don't drink before you drive!
After Sales Services
Please feel free to contact us for any question via
Contact us:
eu_support@ibacheck.com
us_support@ibacheck.com
‰BAC
It will show 0 and avoid
】 & ESC 【
】 key for
ESC
】 is + up; ESC 【
】 is
ESC
ESC
】 to alter the selected digits. Press
ESC
】 to minus number.
】 key to select 12/24
4
metal
object
metal
object
(Europe)
(USA)
6
Advertisement
