iBACheck i1 AA1698 Operation Manual

Operation Manual
AA1698 / AA198
Breath Alcohol Tester
English
Thanks for purchasing our iBACheck
Digital Alcohol Breath Analyzer. Model gives you a digital reading of your
breath alcohol content and your possible concentration of alcohol
intoxication.
Important
To begin, rinse your mouth with fresh water before using the device.
Abstain from smoking or drinking for at least 15 minutes. If you perform
a test just after drinking, the reading will fluctuate from very high to low
reading, i.e. it will drop gradually. It is due to the alcohol residues inside
your mouth that effects the test values. This will also happen with
aromatic drinks, alcoholic mouthwashes or mouth sprays, medicines or
drug, as well as by burping and vomiting.
Also, when alcohol enters the blood through the alimentary canal
(mouth, stomach, and intestines), it is distributed through every part of
the body, including the lungs. This period will last for about 15~30min-
utes before stable. Our device detects human breath and gives a digital
reading out of a person's approximate Blood Alcohol Concentration
(known from here on as BAC). If user direct blow very high concentra-
tion into the sensor, its surface will be surrounded by lots of ethanol
particles, which need to wait for 10 min for evaporation.
Battery Power
Install the provided 3.7V Li ion battery (10440) into the battery
compartment and fully charge the tester before use. Attention: The
reading is invalid if the battery power is low. When there is not enough
battery power, the battery icon 【
return to the 【 RTC 】 mode.
The reading is not reliable when low power and you should charge the
machine immediately. Please connect the provided USB cable and
charge the machine. The LOGO will turn to red and the battery bar will
move forward and backward. The red logo will turn off when the battery
is fully charged.
i1
i1
Alcohol Tester, a hand-held
】 will flash and the tester will
1
After Sales Services
Please feel free to contact us for any question via
Contact us: eu_support@ibacheck.com (Europe)
us_support@ibacheck.com (USA)
Specification subjects to change without notice
Made in China
English
Insert the provided Mouthpiece into the gas inlet located aside of
the LCD screen.
(1) Pressing the START 【 】 Key 1 second to turn on the power and
enter into the Digit Alcohol Computer mode 【 DAC 】 , sensor pre-
heating will be activated for an approximate 20 seconds.
If the machine has already turned on, just press
to activate sensor pre-heating, 【 PH 】 will flashes for 6 times and then
start to counts down.
(2) When count down to zero, 【 BLOW 】 flashes with beep tone. It is
ready to start testing & there will has a
detect function. User can preform either
(3)
Press the START 【 】 Key, 【 BLOW 】 light shown. Please start to
blow through the mouthpiece steadily and continuously for
approximately 6 seconds.
While blowing, a long beep will be heard and please keep blowing. When
the beep tone stops, sampling finishes and the test result reading will be
shown on the display immediately.
START 【 】 Key once
5s count down period for auto
or 4)
2