Advertisement
Quick Links
SPECIFICATIONS
CONTENTS
Power source
Power source (only for Korea)
Power consumption
Power consumption (only for Korea)
Motor voltage
Charging time
Weight
Supplied accessories
Page
Wet/Dry Rechargeable Shaver
ES4001
AC100-120V/220-240V, 50-60Hz
(Automatic voltage conversion)
AC110-220V, 60Hz
Cleaning brush
2
2
3
© 2000 Matsushita Electric Works Ltd. All rights
reserved. Unauthorized copying and distribution is a
violation of law.
ORDER NO. SD0004A33C3
25/30mA
30mA
1.2V DC
8-hours
150g
Soft case
Page
6
8
Advertisement
Related Manuals for National ES4001
Summary of Contents for National ES4001
-
Page 1: Table Of Contents
ORDER NO. SD0004A33C3 Wet/Dry Rechargeable Shaver ES4001 SPECIFICATIONS Power source AC100-120V/220-240V, 50-60Hz (Automatic voltage conversion) Power source (only for Korea) AC110-220V, 60Hz Power consumption 25/30mA Power consumption (only for Korea) 30mA Motor voltage 1.2V DC Charging time 8-hours Weight 150g... -
Page 2: Schematic Diagram
ES4001 1 SCHEMATIC DIAGRAM 2 WIRING CONNECTION DIAGRAM... -
Page 3: Disassembly / Assembly Instructions
ES4001 3 DISASSEMBLY / ASSEMBLY INSTRUCTIONS 3.1. MAIN UNIT REPLACEMENT Follow the procedure below to disassemble the main block. 1. Remove Cap, Foil frame and Inner blades. 2. Loosen the two bottom screws and remove the bottom cover. 3. Take out the chassis block from housing by pushing the base of chassis. - Page 4 ES4001 3.2. BATTERY REPLACEMENT 3.3. MODULE REPLACEMENT To remove the battery, fix the top of battery terminal with the The module is soldered to the chassis at 3 points. flat and lifting up the battery pin. 1. Unsolder the three connections to the chassis.
- Page 5 ES4001 Then, install driving head B in the assembly (1) above after inserting driving head B axis into the hole of armature 2 of the motor. 3.5. WATERPROOF RUBBER INSTALLATION The waterproof rubber must be fitted the right way around.
-
Page 6: Troubleshooting Guide
ES4001 4 TROUBLESHOOTING GUIDE... - Page 7 ES4001 NOTE: The charging current fluctuates depending on the space between charging adaptor and the coil. Please follow the procedure below. 1. Put the coil and the bottom cover close together. 2. Put the bottom cover and the charging adaptor close together.
-
Page 8: Exploded View & Replacement Parts List
ES4001 5 EXPLODED VIEW & REPLACEMENT PARTS LIST 5.1. EXPLODED VIEW... - Page 9 ES4001 5.2. REPLACEMENT PARTS LIST NOTE: *A=available as an optional accessory *B=only available as set *C=available individually Ref. No. Part No. Part Name & Description Remarks Per Unit WES4001X7158 PROTECTIVE CAP (BG) WES9837E OUTER FOIL WES4001S0047 OUTER FOIL FRAME (BG)