Advertisement
Using the TENS Unit
Note: Before first use, fully charge the TENS unit.
1.
Connect the lead pins to the connectors on the
electrodes. Then, place the electrodes on your skin
(with the TENS unit turned OFF). Each wire has 2 leads
with pin-inserted connectors. Make sure the metal on
the pins is not exposed.
Note: This TENS unit has 4 independent channels
(A1, A2, B1, B2). Make sure you know which
channel(s) you want to use before you connect
wires to the TENS unit.
2.
Insert the lead wire plugs into the sockets on the TENS
unit. You can use up to 4.
3.
Press
to turn on the TENS unit. Wait 2 seconds for
the TENS unit to fully turn on.
4.
Select 1 of 15 therapy modes. The selected icon will
flash on the screen and show the corresponding
number.
Note:
• You can only use 1 therapy mode at a time.
• The TENS unit will automatically default to the
last mode selected.
5.
Optionally, press
to increase the time by 10-minute
increments for up to 60 minutes. The time will show on
the screen. The default time is 20 minutes.
6.
Press
or
to begin the treatment. Press again to
increase the intensity.
Note:
• Intensity can be adjusted independently for A and
B channels.
• Press
/
repeatedly on the left side and right
side to raise or lower intensity for channel A (A1
and A2 output) and channel B (B1 and B2 output).
• Lowering both intensities to 0 will reset the timer.
Caution:
• Do not remove electrode pads by pulling on the
wire. Peel gently from any corner.
• Do not place electrodes on the carotid artery,
throat, backbone, or spine.
• If you feel pain, dizziness, discomfort, or nausea
while using the TENS unit, stop using immediately
and call your physician or medical practitioner.
Do not exceed your comfort level.
7.
Press
to pause the treatment at any time.
Press
again to resume.
Note: If no buttons are pressed for 3 minutes, the
TENS unit will turn off automatically.
8.
Press and hold
for 2 seconds to turn off the TENS
unit at any time.
9.
Unplug the electrodes from the TENS unit. Then peel
the pads off the skin gently and replace on the plastic
film. Never remove pads from skin before turning off
the TENS unit.
Advertisement
