Hitachi CP-X301 Setting Up page 3

Hide thumbs Also See for CP-X301:

The other socket on the back of the wedge monitor is for the black power cable, which

should be running under the front row of chairs with the grey monitor cable. The

power cable can be plugged in now. Please note, if the wedge monitor is not required

for a particular service or event, then the projector will work perfectly well without

the grey cable connected to it.

The power cable for the projector should be inserted into the socket on the side (see

diagram below, outlined with red dashed line).

If sound (audio) output is required from the computer, this can be fed into the

amplifier/loudspeaker system by connecting the black cable with two different sized

jack plugs on each end (similar to those seen on the right). The smaller end goes

into the light green socket on the left hand side of the computer (marked „5‟ in the

picture below).

The larger end should be put into the „AUDIO IN‟ socket on the

wall box near the end of the first row of chairs. The „AUDIO

LEVEL‟ knob can be used to help balance the volume of the

signal coming from the computer.

If no sound from the computer is required during the service it

is best not to make these connections, otherwise the

congregation may become aware of the various beeps and other

sounds that computers make on a regular basis.