Table of Contents
Advertisement
10. Alignment
10.1. Pedestal setting (C)
Note:
OSD is the difference between UY model and Except UY model. / Picture: Normal (Except UY)/
Standard (UY model) / White balance (Except UY)/Color Temp (UY model)
10.2. Pedestal setting (B)
Note:
OSD is the difference between UY model and Except UY model. / Picture: Normal (Except UY)/
Standard (UY model) / White balance (Except UY)/Color Temp (UY model)
10.3. NTSC panel white balance
10.4. PAL / SECAM panel white balance
10.5. PC / RGB panel white balance
10.6. HD / 525i / 525p / 625I / 625P panel white balance
11. Trouble shooting guide
11.1. Self Check
1. Self-check is used to automatically check the bus line controlled
circuit of the Plasma display.
2. To get into the Self-check mode, press the volume down button on
the customer controls at the front of the set, at the same time
pressing the OFF-TIMER button on the remote control, and the
screen will show :-
If the CCU ports have been checked and found to be incorrect
Or not located then " - - " will appear in place of " OK "
17
Advertisement
Table of Contents
