Panasonic H-37PA60H Service Manual page 6

The Lead Free Solder used in our manufacturing process and discussed below is (Sn+Ag+Cu).
That is Tin (Sn), Silver (Ag) and Copper (Cu) although other types are available.
This model uses Pb Free solder in it's manufacture due to environmental conservation issues. For
service and repair work, we'd suggest the use of Pb free solder as well, although Pb solder may be
used.
PCBs manufactured using lead free solder will have the PbF within a leaf Symbol
stamped on the back of PCB.
Caution
- Pb free solder has a higher melting point than standard solder. Typically
the melting point is 50 ~ 70 °F (30~40 °C) higher. Please use a high
temperature soldering iron and set it to 700 ± 20 °F (370 ± 10 °C).
- Pb free solder will tend to splash when heated too high (about 1100 °F
or 600 °C).
If you must use Pb solder, please completely remove all of the Pb free
solder on the pins or solder area before applying Pb solder. If this is not
practical, be sure to heat the Pb free solder until it melts, before
applying Pb solder.
- After applying PbF solder to double layered boards, please check the
component side for excess solder which may flow onto the opposite
side. (see figure below)
Suggested Pb free solder
There are several kinds of Pb free solder available for purchase. This product uses Sn+Ag+Cu (tin,
silver, copper) solder. However, Sn+Cu (tin, copper), Sn+Zn+Bi (tin, zinc, bismuth) solder can also be
used.
6