· Never run the wiring on the outside of the vehicle or under it where it can be damaged by road hazards or the moving parts of the vehicle. Use existing wire channels, sills, panels and molding strips inside the vehicle to hide the wiring for safety and a neat appliance. ·...
Page 4
· After cutting and drilling all holes, inspect the mounting areas for any metal burrs or rough edges. File any area that may interfere with the mounting of the speaker. · Clean any metal shavings from the mounting area and check for areas in which water may enter the speaker cavity. Treat the area for water protection when necessary.
Page 5
- fix the speaker grill by screws. If unit fails to operate properly · Carefully read the instruction to make sure the unit is being operated properly. Check the following before you take your unit to the local dealer for repair.
Specification Loudspeaker one woofer: 13 cm (5.25 ) injection-molded polypropylene cone TW: 25 mm (1 ) silk dome Magnet main: ferrite 7.8 Oz magnet tweeter: neodymium Peak output power 160 W Rated output power 80 W Impedance 4 hm Sensitivity 92 dB Frequency response 85-21000 Hz...