Activating Wi-Fi On The Appliance; Deactivating Wi-Fi On The Appli- Ance; Software Update; Resetting The Appliance Network Settings - Bosch WAV32M40TH User Manual And Assembly Instructions

en Home Connect
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡ Press Start / Reload / Pause
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
Activating Wi-Fi on the appli-
ance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 4.
2.
a The display shows Con .
Press Start / Reload / Pause
3.
peatedly until the display shows
On .
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Deactivating Wi-Fi on the ap-
pliance
Press and hold Remote Start
1.
at least three seconds.
Set the programme to position 4.
2.
a The display shows Con .
Press Start / Reload / Pause
3.
peatedly until the display shows
OFF .
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
44

Software update

Requirement: The display shows
Upd.
.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 6.
2.
a UdP appears on the display.
Press Start / Reload / Pause
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
for
is in progress.
Resetting the appliance net-
work settings
re-
Press and hold Remote Start
1.
at least 3 seconds.
Set the programme to position 5.
2.
a The display shows rES .
Press Start / Reload / Pause
3.
a The display shows YES .
Press Start / Reload / Pause
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
for
Tip: If you wish to operate your appli-
ance again via the Home Connect
app, you will need to reconnect it to
the Wi-Fi and to the Home Connect
re-
app.

Remote diagnostics

Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
for
.
for
.
.