Pioneer FH-P6600R EW Service Manual page 92

FH-P6600R,P6600
- Removing the Guide Arm Assy Section
1. Remove a connector, a spring A and B
2. Drive the Guide Arm Assy Section up aslant into rear
side direction, then remove it from a Pin. Finally, drive
the assembly approximately 45 degrees upward, then
slide the assembly toward left side to remove it.
Note : When assembling the Guide Arm Assy Section,
route the cord inside the assembly. In this
operation, care must be exercised so that cord may
be caught by the gear.
- Removing the LO Arm Assy Section
1. Remove two Pins to dismount the LO Arm Assy
Section.
- Removing the Control Unit and the Spindle
Motor
1. Remove from the connector after mounting the short
pin on the flexible PCB of the pickup unit.
2. Remove two Soldered joints, then remove two Screws
A.
3. Remove two connectors and a Screw B.
4. Disengage the Control Unit from two Tabs, then
dismount the unit by sliding it toward left.
5. Dismount the Spindle Motor.
92
Guide Arm Assy Section
A
LO Arm Assy Section
Short Pin
Spindle Motor
B
Control Unit
B
Pin
A
A