Pioneer FH-P6600R EW Service Manual page 91

- Removing the Upper Frame
1. Remove six Springs A, two Springs B and four
Screws.
2. Remove two Tabs situated on rear side of the Upper
Frame, remove two Arms on the front side, then
remove two Tabs on the front side.
- Removing the Carriage Mechanism Section
1. Disengage the Carriage Mechanism Section from the
two dampers situated in the front side by driving it
up, then disengage and remove the mechanism from
the one damper by driving it up aslant into front side
direction.
Note : When assembling the Carriage Mechanism
Section, coat the dampers with alcohol prior
to the assembly.
- Removing the Clamp Arm Assy Section
1. Remove a Spring A, a B and a Spring C.
2. Drive the Clamp Arm Assy Section up into rear side
direction, then disengage the arm from its current
position Finally, drive the assembly approximately 45
degrees upward, then slide the assembly toward
right side to remove it.
A
A
A
B
Arm
Arm
A
FH-P6600R,P6600
Upper Frame
A
A
B A
Carriage Mechanism Section
Clamp Arm Assy Section
B
C
91