Lorell 87263 Assembly Instructions

Assembly Instructions (PAGE 1)
STEP 1
Insert the 8 cam screws in
the upper hutch unit (1) as
shown. Insert the 8 Klix
cam locks in the back panel
in the holes provided and
attach the back panel (2).
Secure in place by
tightening the Klix cam
locks. DO NOT
OVERTIGHTEN
Apply vinyl cover over Secure side panels in place
exposed cam lock with the four each screws
"E" as provided.
STEP 2
Insert the 6 Cam Locks and 6
wooden dowels in holes provided.
Insert the 6 additional Klick Cam
locks in holes provided and attache
the two side panels (4 and 5) as
shown. Tighten Klix Cam locks ash
shown.
Apply vinyl cover over
exposed cam lock
IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts
from being scratched.
• Check to make sure that you have all parts and hardware
• Remove all wrapping materials, including staples and packaging straps before your start to assemble.
• Do not tighten all screws/bolts until pieces are completely assembled
• Keep all hardware parts out of children's reach
• It is recommended for 2 persons to complete this assembly
Stack-On Overhead Hutch Unit With Doors
87263/87363
Apply vinyl cover over exposed cam lock
Apply vinyl cover over
exposed cam lock
Assembly Instructions (PAGE 2)
STEP 3
Stack-On Overhead Hutch Unit With Doors
Secure Tackboard in place
with the 6 wood screws
(F) as shown.
COMPLETED ASSEMBLY
87263/87363