Table of Contents
Advertisement
PSODDVR4C-LIVE Installation Guide
Installation notes
Where possible the PSODDVR4C-LIVE should be placed horizontally
with the rear of the PSODDVR4C-LIVE and cables facing the inside of
the vehicle to ensure that the X axis is consistent with the driving
direction and the Y axis is perpendicular to the driving direction.
For the connection of camera and PSODDVR4C-LIVE, the joint of the
extension cable needs to be wrapped with waterproof tape to prevent
water stains from entering the cable core.
2.10. Default View on the Monitor
If a monitor has been installed the PSODDVR4C-LIVE has the ability to show a
default camera view, which is displayed on the monitor during normal operation
when no trigger has been activated. The default view is for 4 Channels to
be viewed. If an alternative view is required then this can be requested via
the Parksafe Technical Support team.
2.11. Triggers
The PSODDVR4C-LIVE allows for the use of inputs to trigger actions, such
as changing the view, generating a video etc. The default setup for the
Triggers is as follows :
NO
Enable
IN1
Emergency
IN2
Reverse
IN3
OFF
If a reverse or indicator trigger is used then changes may be required to view
the correct channel, this can be performed remotely by the Parksafe Technical
Support team.
Elec
Delay
H
1s
H
1s
H
1s
PARKSAFE GROUP
Record
ALM Link
ON
AVI_1
OFF
OFF
OFF
OFF
Page 14 of 15
View
CH1
CH2
CH3
Advertisement
Table of Contents
