Subscribe to Our Youtube Channel
Related Manuals for WaterCop SmartConnect
Summary of Contents for WaterCop SmartConnect
- Page 1 The smart way to get remote mobile control and access to your WaterCop automatic shut-off system. REMOTE WATER MOBILE WIFI NOTIFICATION DIRECT CONTROL APPS COMPATIBLE ALERTS ETHERNET...
-
Page 2: System Description
WaterCop valve to shut off the water supply using an app on your smartphone or tablet. The SmartConnect unit is powered by the WaterCop AUX I/0 port through a CAT5 or CAT6 cable. -
Page 3: System Requirements
SmartConnect device. When running cable from the actuator or control panel to the SmartConnect, use CAT5 or CAT6, and keep the maximum cable length 50' or less. If more than 50' is required to get a good signal, the additional power supply (ACA100) can be used. -
Page 4: Reset To Factory Settings
8. Open the WaterCop SmartConntect App and login, if not still logged in. 9. On the My WaterCop Devices screen, click the blue “Add” button in the top right corner while physically near the WaterCop SmartConnect. After the device pops up, verify the MAC address matches with the label on the device, click the box to select it. -
Page 5: Troubleshooting
Ensure Wi-Fi password 19 characters or less. did not change state” message If you are unable to resolve any of the troubles noted above or experiencing other issues, please contact your Installer directly or WaterCop Customer Service for assistance at 800-545-3636. -
Page 6: Fcc Information
Operation is subject to the following two conditions: 1. This device may not cause interference 2. This device must accept any interference, including interference that may cause undesired operation of the device Visit WaterCop.com for your warranty information. 192616...
Need help?
Do you have a question about the SmartConnect and is the answer not in the manual?
Questions and answers