Advertisement
STARTUP
1. Connect other end of network cable to a PoE+ (Power over Ethernet) network switch or injector on a network with a DHCP server.
2. If properly installed, unit should boot and show time within 30 seconds. See boot sequence below.
3. If IPClockWise is installed on a computer on the same network, it will automatically discover the device and be controllable.
Consult the IPClockWise User Manual (see
on sending audio and text to the device.
BOOT SEQUENCE
When first powered, if properly installed, the device should boot, and then display the time as follows:
1
2
3
4
5
ADDITIONAL RESOURCES
User Support:
Technical Resources:
AND Limited Warranty:
AND Legal Disclaimer:
https://www.anetd.com/portal/
The first screen you will see. This screen should appear within 10 seconds of powering on the
device.
Indicates the IP address of the device. DHCP assigns this network-specific address. Otherwise,
the static address will appear if configured as such. The AND jingle or single tone should
playback over the speaker.
Indicates the network MAC address of the device (configured at the factory).
Indicates the current firmware version of the device.
Once all initialization completes, the time will display. If just a colon displays, it cannot find the
time. Check the NTP server settings, and check that the Internet connection is working.
https://www.anetd.com/user-support/
https://www.anetd.com/user-support/technical-resources/
https://www.anetd.com/warranty/
https://www.anetd.com/legal/
Advanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004
tech@anetd.com
• 847-463-2237 •
Version 1.0
IP Speaker with HD Display (IPSWDHD-MW)
) or third-party software guide for further instructions
www.anetd.com
•
8/19/2021
Quickstart
Advertisement
