ADVANCED Network Devices IPSWD-RWB Installation Instructions

IPSWD/IPSWD-RWB
Version 1.4

Installation Instructions

The following instructions should be followed for IPSWD/IPSWD-RWB installations:
A ferrite is included if there is concern over line performance. Wrap Cat 5 cable around ferrite once
and clamp shut.
Surface Mount Install (uses IPS-SM1 surface mount rear enclosure)
1. Remove rear enclosure, IPS-SM1, from packaging.
2. If running conduit or wiremold to the enclosure, break open the top or bottom wiremold
knockout as desired.
3. Place enclosure or mounting template on wall surface, over the Cat 5 cable access port if not
running cable along the exterior wall, and mark the desired hole pattern to be drilled using the holes
provided in the enclosure surface back.
4. Set enclosure aside and drill pilot holes for anchors or screws to be used on mounting surface.
5. Install anchors (not provided) if used.
6. Feed Cat 5 cable through access port in the enclosure and then fasten the enclosure to the wall
surface at the prepared locations using screws (not provided). Tighten securely.
7. If using wiremold, complete the Cat 5 cable run to the enclosure.
8. Remove front baffle assembly, IPSWD or IPSWD-RWB, from packaging.
9. Remove bag of screws from rear speaker magnet.
10. Complete any additional wiring for accessories, then connect the Cat 5 cable to Ethernet jack J3
on the circuit board. (see Figure A)
11. Place front baffle assembly over the enclosure and thread the four provided screws through the
baffle and into the enclosure at the four corners of the baffle. Tighten securely.
Flush Mount Install (uses IPS-FM1 flush mount enclosure)
1. Remove rear enclosure, IPS-FM1, from packaging.
2. If wall surfaces are already installed, place enclosure on wall surface adjacent to a stud and trace
the perimeter of the enclosure. Cut a hole in the wall along the traced perimeter.
3. Break open the appropriate knockout for the conduit or cable run.
4. Place one side of enclosure on a stud and mark desired pilot holes within the 3 slots provided.
5. Set enclosure aside and drill pilot holes for the screws to be used on
the mounting surface.
6. Place enclosure on the stud over the pilot holes and thread screws
(not provided) into the stud. Tighten securely.
7. Complete the Cat 5 cable run into the enclosure.
8. Remove front baffle assembly, IPSWD or IPSWD-RWB, from
packaging.
9. Remove bag of screws from rear speaker magnet.
10. Complete any additional wiring for accessories, then connect the Cat
5 cable to Ethernet jack J3 on the circuit board. (see Figure A) Figure A
11. Place front baffle assembly over the enclosure and thread the four provided screws through the
baffle and into the enclosure at the four corners of the baffle. Tighten securely.
For additional support, visit www.anetdsupport.com