Adjusting Trim Angle For Hydro Tilt; Models - Yamaha F30A Owner's Manual

Operation
clamp bracket.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
If equipped with a power trim and tilt
G
switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
1. Power trim and tilt switch
1. Power trim and tilt switch
35
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
"
To lower the bow (trim-in), press the switch
"
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EMU27891

Adjusting trim angle for hydro tilt

models

EWM00490
G
G
UP
DN
G
1
ZMU04060
1.
2.
" (up).
" (down).
WARNING
Stop the engine before adjusting the
trim angle.
Be sure all people are clear of the out-
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
Stop the engine.
Place the tilt lock lever in the release po-
sition.