Weaver W-987 Manual

Weaver W-987 Manual

Alu smart modes
Hide thumbs Also See for W-987:

Advertisement

ALS2: Two User-Defined Tape Weights

● Make sure the wheel balancer has been calibrated before balancing a wheel in
ALS2. If the distance arm is not calibrated, it will cause an inaccurate balance.
● Place the distance arm at the desired inside tape weight location, hold the arm in
place and the machine will beep (see image below)
● Without returning the distance arm to the home position, immediately place the
distance arm to your desired outside tape weight location, hold the arm in place
and the machine will beep (see image below)
ALU Smart Modes For W-987
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W-987 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Weaver W-987

  • Page 1 ALU Smart Modes For W-987 ALS2: Two User-Defined Tape Weights ● Make sure the wheel balancer has been calibrated before balancing a wheel in ALS2. If the distance arm is not calibrated, it will cause an inaccurate balance. ● Place the distance arm at the desired inside tape weight location, hold the arm in place and the machine will beep (see image below) ●...
  • Page 2 ● The machine will automatically enter the ALS2 mode. ● Lower hood to spin ● After the spin, rotate the wheel to the inner position shown on the display. The machine’s laser will turn on and you will add the weight at 6 o’clock to the inside of the wheel.
  • Page 3 Important Note: If the distance between your tape weights is less than 4” or 5”, this could cause an inaccurate balance. The weights should be greater than 4” or 5” apart. The arrows shown in this diagram represent the distance between the wheel weights.
  • Page 4 ALS1: Inner Clip-on Weight and User Defined Outer Tape Weight ● Make sure the wheel balancer has been calibrated before balancing a wheel in ALS1. If the distance arm is not calibrated, it will cause an inaccurate balance. ● When you are at the home screen press the mode button until ALS1 shows (see image below) ●...
  • Page 5 ● Rotate the wheel to the inner position shown on the display and hammer the clip-on weight at 12 o’clock ● Rotate the wheel to the outer position shown on the display. The machine’s laser will turn on and you will add the weight at 6 o’clock to the outside of the wheel. In this case, the weight called for is 1.00 oz, so we placed 0.50 oz on each side of the laser (see images below).
  • Page 6 Important Note: If the distance between your weights is less than 4” or 5”, this could cause an inaccurate balance. The weights should be greater than 4” or 5” apart. The arrows shown in this diagram represent the distance between the wheel weights. The machine is very accurate and if the weights are too close together, it will cause the machine to have trouble distinguishing between the inner plane and outer plane of the wheel.

This manual is also suitable for:

W-987m

Table of Contents