Hitachi 36SDX01S Operating Manual page 26

PIP
PiPC
It is also possible to customize the PiPC position. To do this, wait until the On-Screen Display disappears (about eight seconds) and
then use the CURSOR ,
NOTE: PinPC works correctly when receiving the following signal timings, horizontal and vertical position of PinPC
may not work correctly with other timings.
Signal Resolution
VGA 640x480
VGA 640x480
SVGA 800x600
NOTE: Component input with High Definition (1080i) and Standard Definition (480P) Digital signals do not show
up on the PinPC sub-picture because digital decoding is only for the main picture.
NOTE: If PinPC is activated, the remote control mouse operation does not work. Use the PC mouse for control
instead of the remote control mouse.
Main Picture
PC:RGB1
PIP
PiPC
Sub Picture
(Large)
buttons. Press CURSOR ,
SECONDS
Horizontal
Freq. (kHz) Polarity
31.5 Negative
37.8 Negative
37.8
PC:RGB1
to select Audio Input source to TV or PC mode.
EXIT
AFTER
F AV
F AV
EIGHT
CH
CH
Vertical
Freq. (Hz) Polarity
60 Negative
72 Negative
Positive 60 Positive
26
PICTURE-IN-PC
PIP
PiPC
Sub Picture
(Small)
PC:RGB1