Prepare To Install Your Hard Drive; Opening Your Computer; Unpackaging Your Hard Drive - IBM Ultrastar 18ZX Installation Manual

IBM storage products
Step 2: Prepare to install your hard drive

Opening your computer

1. Turn the system off.
2. Unplug the power cord from the wall outlet.
3. Remove all cables from the back of your computer, labeling them if necessary.
4. Remove the cover from your computer. (Consult your user's guide for instructions if needed.)

Unpackaging your hard drive

1. Remove the drive from the anti-static package that it was shipped in.
2. Handle the drive by the sides only.
3. Do not touch the main computer chip board.
4. Do not drop. A drop of only 1/4 inch could permanently damage your hard drive.
5. If available, use an ESD (Electronic Static Discharge) wrist strap while handling your drive.
6. Place the drive carefully on a static free area.
Step 3: Jumper Settings
The jumper settings are found on the hard drive on the opposite end of the interface connector. (See the
diagram on page 9.) These are physical settings that can be changed to allow for different uses of your
hard
BIT 3
drive.
off
SCSI ID off
Jumper
off
s
off
Each
off
SCSI
off
device
off
will need
to have off
it's own
on
SCSI ID.
on
You can
on
use ID 0
on
through
ID 15
on
reservin
on
g ID 7
on
for your
on
controlle
r card. Follow the table below to set an ID on your SCSI drive.
IBM Hard Disk Drive Technical Support Center
BIT 2 BIT 1
off off
off off
off on
off on
on off
on off
on on
on on
off off
off off
off on
off on
on off
on off
on on
on on
BIT 0
off
on
off
on
off
on
off
on
off
on
off
on
off
on
off
on
Page 8
Address
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
version 1.0