Advertisement
Hitachi Global Storage Technologies
Mounting Recommendations
•
The temperature of the center of the hard drive cover should remain less than 65°C at all times.
•
The inertia of the chassis around the Z-axis of the gravity center of the device must be more than 3 x
-4
10
•
In case of general Sub-notebook PC weight (1.7kg), the inertia of the chassis around the Z-axis of the
gravity center of the device is greater than 100 x 10
not conflict with the general electronic equipment.
•
If installing the 7K200 next to a steel plate, the cover of the 7K200 and the steel plate must have at
least 2mm of space between them. This is necessary for air flow and cooling requirements.
•
The PCBA side of the drive should be covered with insulation if it is in contact with any metal part of
the host system. Contact between the PCBA and metal may result in drive failure.
•
The blue frame shown below represents the casing used when the drive can not be secured with screws.
Page 2
2.
kg m
-4
2
kg m
. Therefore, the required inertia level does
version 1.0
Advertisement
