Advertisement
Step 7: The legs are then attached to the worktop with 4
pcs of 60mm screws (6), 2 pcs per leg.
Step 9: Attach handles (22) to the front of the drawer (17)
with 8 pcs of 40mm drawer screws (23), 2 pcs per drawer.
Step11: The back of the drawer (18) is attached to the two
side parts by using 4 pcs of 30mm screws (13), 2 pcs per
side. Then insert the bottom of the drawer.
Step13: When inserting the drawers, make sure the runner
clip is facing forwards see picture, then slide the drawers
into the guides.
© Jack Sealey Limited
Step 8: The partition is also attached to the frame with 2
pcs of 35mm screws (14). WARNING! there are no pre
drilled holes.
Step10: The two side parts of the drawer (19 & 20) are
attached to the front of the drawer with 2 pcs of 30mm
screws (13) per side, 4 pcs per drawer.
Step12: After installing the drawers, check whether the
inner tracks of the drawer pull outs are pushed all the way
forward if not, then push all the way forward.
Step14: Fasten the holding rods (10) and the bench hooks
(11) in the holes provided in the worktop.
Original Language Version
AP1640 Issue:1 17/05/22
Advertisement
