Fan; Rear Panel - Toshiba D-R1SB Service Manual

1-1-5. Fan

(1) Remove the two pieces of tape (1).
(2) Cut off the binding band (2).
(3) Disconnect the connector (3).
(4) Remove four screws (4) and nuts (5) to remove the fan (6).
(Note)
• After replacing, tape on two points (1) as they were.
• Pass the wire (7) underneath the folded part of the acrylic board.
Pass the wire (7)
underneath the
folded porton

1-1-6. Rear Panel

(1) Remove eight screws (1) and four screws (2).
(2) Remove the rear panel (3).
wire (7)
Nuts (5)
Acrylic board
Tape (1)
Binding band (2)
Rear panel (3)
Tape (1)
Wire (7)
Fan (6)
Fig. 2-1-5
Screws (1)
Screws (1)
Fig. 2-1-6
Screws (4)
Connector (3)
Screws (2)
Screw (1)