Fan; Rear Panel; Disconnect The - Toshiba D-R1SU Service Manual

1-1-5. Fan

(1) Remove the two pieces of tape (1).
(2) Cut off the binding band (2).
(3) Disconnect the connector (3).
(4) Remove four screws (4), and then remove the fan (5).
(Note)
• After replacing, tape on two points (1) as they were.
• Pass the wire (6) underneath the folded part of the acrylic board.
Pass the lead (6)
underneath the
folded porton

1-1-6. Rear Panel

(1) Remove the fan. (Refer to 1-1-5.)
(2) Remove ten screws (1) and the rear panel (2).
Lead wire (6)
Acrylic board
Tape (1)
Binding band (2)
Rear panel (2)
Tape (1)
Fan (6)
Fan (5)
Fig. 2-1-5
Screws (1)
Fig. 2-1-6
Screws (4)
Connector (3)
Screws (1)