Operation - HOGERT HT2C503 User Manual

Service address: GTV Sp. z o.o. Sp. K., ul. Przejazdowa 21, 05-800 Pruszków, Poland.
Work with the burner in clean places, away from flammable or greasy materials and use eye and hand protection. When the burner is
not to be used for a long time or for transport, the gas container must be removed.

OPERATION

Installation of the gas container
The burner is only suitable for use with gas containers according to EN 417 with a self-sealing threaded connection. Other models of
gas containers or containers that do not comply with EN 417 are not permitted.
Install the gas container outdoors or in well-ventilated areas. Keep a distance from fire or heat sources and bystanders. First close
the gas valve by releasing the trigger button and turning it clockwise to the „OFF" marking. Make sure that the gasket is not damaged
or worn. If any signs of wear or damage are observed, the installation of a gas container is prohibited. Grasp the gas container and
burner vertically in your hand. Then screw the gas container clockwise to the burner valve seat until it stops. Check the tightness of
the connection.
Warning! It is forbidden to use the burner with an improperly installed gas container. Make sure there are no gas leaks, preferably
with soapy water. It is forbidden to work with a burner in which a gas leakage was found.
Burner operation
Make sure there are no gas leaks before starting operation. To start the burner, turn the gas adjustment knob counterclockwise by
1/8th turn. Then turn the trigger button in a counterclockwise direction in the direction marked „ON" and press it, which will unlock
the gas valve and start the piezo igniter. Adjust the flame using the gas adjustment knob. You can operate continuously by pressing the
trigger lock button and it is not necessary to hold the trigger button. After lighting the gas, it is advisable to wait about one minute until
the burner heats up, which should be in a vertical position. The flame of gas should be observed during this time. In the initial phase
there may be a slight phenomenon of flickering. If it does not go out spontaneously, extinguish the flame and contact the manufacturer.
If the flame colour changes from blue to orange, the burner must also be returned to an authorised service centre
Warning! Do not put down or heat the burner when it is lit.
Burner extinguishing
To extinguish the burner, release the trigger button. At this point the valve will automatically cut off the gas supply and the flame will go
out. If the burner was in continuous operation, press the trigger button and then release it. Then the flame will go out spontaneously.
Allow the burner to cool down completely.
Warning! It is forbidden to immerse or pour water over the burner for cooling purposes.
Disconnect gas container
The gas container can be dismantled at any time, even if it has not been completely emptied. To do this, turn the trigger button cloc-
kwise towards the „OFF" symbol until it stops. Wait until all burner components have completely cooled down. Then unscrew the gas
container by turning it in the opposite direction to the direction of the pointer.
Maintenance
Clean the device with a damp cloth. Larger dirt should be cleaned with soapy water. Do not use abrasive cleaners. In case of any mal-
functions or contamination of the nozzle, stop using the burner and contact the manufacturer's service point. It is forbidden to modify
the burner and to clean the nozzle by yourself, especially with sharp objects.
Storage
Store the device in an upright position in a dry and well-ventilated place, inaccessible to unauthorised persons, especially children.
4
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków