JVC KD-X482BT Instruction Manual page 22

Audio Settings
Speaker output settings
[SPK/PRE OUT]
(Applicable only if [X ' OVER TYPE ] is set to [2-WAY]) (page 21)
Select the output setting for the speakers [SPK/PRE OUT], based on the speaker
connection method.
Connection via lineout terminals
For connections through an external amplifier (Page 35)
KD-X482BT:
Setting on
[SPK/PRE OUT]
FRONT
[REAR/REAR] (default) Front speakers
output
[SUB.W/SUB.W] Front speakers
output
KD-X282BT:
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[REAR/SUB.W] (default) Subwoofer output
[SUB.W/SUB.W] Subwoofer output
22
ENGLISH
Audio signal through lineout terminal
REAR
Rear speakers output Subwoofer output
L (left): Subwoofer output Subwoofer output
R (right): (Mute)
Audio signal through lineout terminal
REAR/SW
Connection via speaker leads
You can also connect the speakers without using an external amplifier
but still being able to enjoy the subwoofer output with these settings.
(Page 34)
Setting on
[SPK/PRE OUT]
[REAR/REAR]
[REAR/SUB.W]*
[SUB.W/SUB.W]
SW
If [SUB.W/SUB.W] is selected:
– [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available.
(Page 24)
– [POSITION R02] is selected in [FADER] and selectable range is [POSITION R15] to
[POSITION 00]. (Page 21)
* Except for KD-X482BT.
Audio signal through rear speaker lead
L (left)
Rear speakers output Rear speakers output
Rear speakers output Rear speakers output
Subwoofer output
R (right)
(Mute)