Command Format; Command Data - Hitachi CP-X417 Technical Manual

Command Format

[TCP #23]
1. Protocol
Consist of header (7 bytes) + command data (6 bytes)
2. Header
BE + EF + 03 + 06 + 00 + CRC_low + CRC_high
CRC_low: Lower byte of CRC flag for command data
CRC_high: Upper byte of CRC flag for command data

3. Command data

Command data chart
byte_0 byte_
Action
low high
Action (byte_0 - )
Action Classification
 Set
2 Get
4 Increment
5 Decrement
6 Execute
Requesting projector status (Get command)
() Send the following request code from the PC to the projector.
Header + Command data ('02H' + '00H' + type (2 bytes) + '00H' + '00H')
(2) The projector returns the response code '1DH' + data (2 bytes) to the PC.
Changing the projector settings (Set command)
() Send the following setting code from the PC to the projector.
H eader + Command data ('01H' + '00H' + type (2 bytes) + setting code (2 bytes))
(2) The projector changes the setting based on the above setting code.
(3) The projector returns the response code '06H' to the PC.
Using the projector default settings (Reset Command)
() The PC sends the following default setting code to the projector.
Header + Command data ('06H' + '00H' + type (2 bytes) + '00H' + '00H')
(2) The projector changes the specified setting to the default value.
(3) The projector returns the response code '06H' to the PC.
Increasing the projector setting value (Increment command)
() The PC sends the following increment code to the projector.
Header + Command data ('04H' + '00H' + type (2 bytes) + '00H' + '00H')
(2) The projector increases the setting value on the above setting code.
(3) The projector returns the response code '06H' to the PC.
Command Control via the Network (continued)
byte_2 byte_3
Type
low high
Change setting to desired value.
Read projector internal setup value.
Increment setup value by .
Decrement setup value by .
Run a command.
byte_4 byte_5
Setting code
low high
Content